193
Reference Manual
00809-0100-4021, Rev GC
Appendix A: Reference Data
April 2014
Reference data
External ground screw assembly
The external ground screw assembly can be ordered by specifying code G1 when an enclosure is
specified. However, some approvals include the ground screw assembly in the transmitter
shipment, hence it is not necessary to order code G1. The table below identifies which approval
options include the external ground screw assembly.
Hardware tag
No charge
2 lines of 28 characters (56 characters total)
Tags are stainless steel
Permanently attached to transmitter
Character height is
1
/16-in. (1.6mm)
A wire-on tag is available upon request. 5 lines of 12 characters (60 characters total)
Software tag
HART transmitter can store up to 8 characters in HART 5 mode and 32 characters in
HART 7 mode. F
OUNDATION fieldbus transmitters can store up to 32 characters.
Can be ordered with different software and hardware tags.
If no software tag characters are specified, the first 8 characters of the hardware tag are
the default.
Approval type External ground screw assembly included
(1)
(1) The parts contained with the G1 option are included with the Integral Protector option code T1. When ordering T1, the G1 option code
does not need to be ordered separately.
E5, I1, I2, I5, I6, I7, K5, K6, KB, NA No–Order option code G1
E1, E2, E4, E7, K1, K7, KA, N1, N7, ND Yes
To Next Page
Loading...
Need help?
General
