Emerson Rosemount - 6.12 Operation and maintenance; 6.12.1 Proof test

172
Reference Manual
00809-0100-4021, Rev GC
Section 4: FOUNDATION fieldbus Configuration
April 2014
Foundation™ fieldbus configuration
4.11.2 LCD display
Note
For Rosemount 3144P transmitters with F
OUNDATION fieldbus, the following LCD display options
are not used: Bar graph, Sensor 1, Sensor 2, Differential, Multidrop, and Burst Mode.”
Table 4-13. LCD Display Error Warning Descriptions
Message
LCD display
top line
LCD display
bottom line
RB.DETAILED_STATUS
Sensor Transducer Block Error “Error” “DVICE”
Manufacturing Block Integrity Error “Error” “DVICE”
Hardware/Software Incompatible “Error” “DVICE”
Non-volatile Memory Integrity Error “Error” “DVICE”
ROM Integrity Error “Error” “DVICE”
Lost Deferred NV Data “Error” “DVICE”
NV Writes Deferred No Errors Displayed
ADB Transducer Block Error No Errors Displayed
STB.SENSR_DETAILED_STATUS
Invalid Configuration “Error” “SNSOR”
ASIC RCV Error “Error” “SNSOR”
ASIC TX Error “Error” “SNSOR”
ASIC Interrupt Error “Error” “SNSOR”
Reference Error “Error” “SNSOR”
ASIC Configuration Error “Error” “SNSOR”
Sensor 1 Open “Error” “SNSOR”
Sensor 1 Shorted “Error” “SNSOR”
Terminal (Body) Temperature Failure “Error” “SNSOR”
Sensor 1 Out of Operating Range No Errors Displayed
Sensor 1 Beyond Operating Limits “Error” “SNSOR”
Terminal (Body) Temperature Out of Operating Range No Errors Displayed
Terminal (Body) Temperature Beyond Operating Limits “Error” “SNSOR”
Sensor 1 Degraded “Error” “SNSOR”
Calibration Error “Error” “SNSOR”
Sensor 2 Open “Error” “SNSOR”
Sensor 2 Shorted “Error” “SNSOR”
Sensor 2 Out of Operating Range No Errors Displayed
Sensor 2 Beyond Operating Limits “Error” “SNSOR”
Sensor 2 Degraded “Error” “SNSOR”