Emerson Rosemount - Page 183

173
Reference Manual
00809-0100-4021, Rev GC
Section 4: FOUNDATION fieldbus Configuration
April 2014
Foundation™ fieldbus configuration
The following are the default tags for each of the possible Function blocks which display data on
the LCD display.
All other custom tags that are entered must be: numbers 0 - 9, letters A - Z, and/or spaces.
The following are the standard temperature units codes displayed on the LCD display.
All other custom units that are entered must be: numbers 0 - 9, letters A - Z, and/or spaces.
If the value of the process variable displayed has a bad or uncertain status, the following is
shown:
Sensor Drift Alert “Error” “SNSOR”
Hot Backup Active “Error” “SNSOR”
Thermocouple Degradation Alert “Error” “SNSOR”
Block name LCD display bottom line
Transducer “TRANS”
AI 1400 “AI 14”
AI 1500 “AI 15”
AI 1600 “AI 16”
PID 1700 “PID 1”
PID 1800 “PID 1”
ISEL 1900 “ISEL”
CHAR 2000 “CHAR”
ARITH 2100 “ARITH”
OSPL 2200 “OSPL”
Units LCD display bottom line
Degrees C “DEG C”
Degrees F “DEG F”
Degrees K “DEG K”
Degrees R “DEG R”
Ohms “OHMS”
Millivolts “MV”
Percent (%) Uses the percent symbol
Status LCD display bottom line
Bad “BAD”
Uncertain “UNCTN”
Table 4-13. LCD Display Error Warning Descriptions
Message
LCD display
top line
LCD display
bottom line