Emerson Rosemount - Page 47

37
Reference Manual
00809-0100-4021, Rev GC
Section 3: HART commissioning
April 2014
HART® commissioning
Figure 3-6. 3144P Device Dashboard HART 7- Service Tools
Overview
Configure
Service Tools
Service Tools
1. Alerts
2. Variables
3. Trends
4. Maintenance
5. Simulate
Variables
1. Variable Summary
2. Primary Variable
3. Secondary Variable
4. Third Variable
5. Fourth Variable
6. Analog Output
Trends
1. Sensor 1 Temperature
2. Sensor 2 Temperature
3. Differential Temperature
4. Average Temperature
5. Terminal Temperature
6. First Good Temperature
Primary Variable
1. Primary Variable
2. Parameter
3. PV Gauge
Second Variable
1. Second Variable
2. Parameter
3. SV Gauge
Third Variable
1. Third Variable
2. Parameter
3. TV Gauge
Fourth Variable
1. Fourth Variable
2. Parameter
3. FV Gauge
Analog Output
1. Analog Output Value
2. AO Gauge
Maintenance
1. Thermocouple Diag Snsr 1
2. Thermocouple Diag Snsr 2
3. Min/Max Tracking
4. Sensor Calibration
5. Analog Calibration
Simulate
1. Perform Loop Test
Sensor Calibration
1. Calibrate Sensors
2. Restore Factory Cal
3. Sensor 1 Lower Cal
4. Sensor 1 Upper Cal
5. Sensor 2 Lower Cal
6. Sensor 2 Upper Cal
7. Active Calibrator
Active Alerts
1. Good (only if no alerts)
2. Failed (Fix Now)
3. Advisory
4. Maintenance (Fix Soon)
Failed
1. Invalid Configuration
2. Electronics Failure
3. Calibration Error
4. Sensor Drift Alert Active
5. Sensor 1 Open
6. Sensor 2 Open
7. Sensor 1 Short
8. Sensor 2 Short
9. Terminal Temperature Failure
10. Device Malfunction
Advisory
1. Calibration Error
2. Configuration Changed
Good
1. No Active Alerts
Maintenance
1. Hot Backup Active
2. Sensor Drift Alert Active
3. Sensor 1 TC Degraded
4. Sensor 2 TC Degraded
5 Sensor 1 Excess EMF
6. Sensor 2 Excess EMF
7. Sensor 1 Out of Operating Range
8. Sensor 2 Out of Operating Range
9. Terminal Temperature Out of
Range
10. Primary Out of Limits
11. Analog Output Saturated
12. Analog Output Fixed
13. Simulation Active
14. Non-Primary Variable out of
Limits
Analog Calibration
1. Analog Trim
2. Scaled Trim
Thermocouple Diag Sensor X
1. Resistance
2. Sensor X Status
3. Threshold Exceeded
4. TC Diag Config
TC Diag Config
1. TC Diag Mode Snsr X
2. Trigger Level
3. Baseline resistance
4. Reset Baseline
Min/Max Tracking
1. Min/Max Mode
2. Reset All Min/Max Values
3. Parameter 1
4. Parameter 2
5. Parameter 3
6. Parameter 4
Parameter X
1. Parameter X
2. Maximum Value
3. Minimum Value
4. Reset Parameter X
Key
Bold = Menu Title
Underline = Method
3144P HART Revision 7
Menu Trees – Service Tools