EMKO EPC-1 - Page 44

Feeding Parameter (EPC 3&4)
Page Step No
Step1 Day=1
Step2 Day=8
Step3 Day=10
Step4 Day=14
Step5 Day=20 Step6 Day=30
Step7 Day=32
Step8 Day=36
Step9 Day=38
Step10 Day=40
Day=12
At the graphic above, it is seen how feeding is working in curve mode.
On 12. Day FEEDING PARAMETERS CURVE STEP 3 page is used for feeding (curve mode is enabled).
The same page parameters are also used for 10, 11, 12, 13. Days. On 14. Days FEEDING PARAMETERS
CURVE STEP 4 page parameters are used.
The explanation of the graphic is below;
SET VALUES PAGE DAY parameter is the current day.
- If SET VALUES PAGE DAY parameter is lower than CURVE STEP2 DAY parameter then FEEDING
PARAMETERS CURVE STEP 1 parameters are used by curve.
- If SET VALUES PAGE DAY parameter is higher than CURVE STEP2 DAY parameter or equal to it and it is
lower than CURVE STEP3 DAY parameter then FEEDING PARAMETERS CURVE STEP 2 parameters are
used by curve.
- If SET VALUES PAGE DAY parameter is higher than CURVE STEP3 DAY parameter or equal to it and it is
lower than CURVE STEP4 DAY parameter then FEEDING PARAMETERS CURVE STEP 3 parameters are
used by curve.
- If SET VALUES PAGE DAY parameter is higher than CURVE STEP4 DAY parameter or equal to it and it is
lower than CURVE STEP5 DAY parameter then FEEDING PARAMETERS CURVE STEP 4 parameters are
used by curve.
- If SET VALUES PAGE DAY parameter is higher than CURVE STEP5 DAY parameter or equal to it and it is
lower than CURVE STEP6 DAY parameter then FEEDING PARAMETERS CURVE STEP 5 parameters are
used by curve.
- If SET VALUES PAGE DAY parameter is higher than CURVE STEP6 DAY parameter or equal to it and it is
lower than CURVE STEP7 DAY parameter then FEEDING PARAMETERS CURVE STEP 6 parameters are
used by curve.
- If SET VALUES PAGE DAY parameter is higher than CURVE STEP7 DAY parameter or equal to it and it is
lower than CURVE STEP8 DAY parameter then FEEDING PARAMETERS CURVE STEP 7 parameters are
used by curve.
- If SET VALUES PAGE DAY parameter is higher than CURVE STEP8 DAY parameter or equal to it and it is
lower than CURVE STEP9 DAY parameter then FEEDING PARAMETERS CURVE STEP 8 parameters are
used by curve.
- If SET VALUES PAGE DAY parameter is higher than CURVE STEP9 DAY parameter or equal to it and it is
lower than CURVE STEP10 DAY parameter then FEEDING PARAMETERS CURVE STEP 9 parameters are
used by curve.
- If SET VALUES PAGE DAY parameter is higher than CURVE STEP10 DAY parameter or equal to it then
FEEDING PARAMETERS CURVE STEP 10 parameters are used by curve.
Step1
Step2
Step3
Step4
Step5
Step6
Step7
Step8
Step9
Step10
Day=-5
Day
Day=999
44