EMKO EPC-1 - 6.4.6.4 VENTILATION FUNCTION(BASIC&TUNNEL)

There are two different control outputs.
1. Fan ventilation control(BASIC&TUNNEL VENT):
Basic ventilation fan count is selectable by BASIC FAN COUNT parameters. Remaining fans are tunnel fans. At
this ventilation type, basic fans work only at minimum ventilation and tunnel fans work only at apart from
minimum ventilation.
If calculated ventilation value is less than Min. Vent then output will be equal to Min. Vent value.
If calculated ventilation value is higher than Max Vent then output will be equal to Max Vent value.
FAN1
Min. Vent.
(NOTE1)
House [°C]
FAN1
59
6.4.6.4 VENTILATION FUNCTION(BASIC&TUNNEL)
F.HYS
FANS
Min. Vent.
(NOTE1)
FAN1
A (NOTE2)
B (NOTE2)
C (NOTE2)
VENTILATION ALGORITHM: ON/OFF VENTILATION ALGORITHM: PROPORTIONAL
A (NOTE2)
B (NOTE2)
C (NOTE2)
D (NOTE2)
E (NOTE2)
F (NOTE2)
G (NOTE2)
H (NOTE2)
Settemp
(NOTE1)
Settemp
(NOTE1)
NOTE1:
If curve is enabled;
Settemp= HOUSE TEMP from curve,
Min.Vent= MIN. VENT from curve,
Max.Vent=MAX. VENT from curve.
If curve is disabled;
Settemp= SET VALUES PAGE TEMP.HOUSE,
Min.Vent= SET VALUES PAGE VENT. MIN,
Max.Vent= SET VALUES PAGE VENT. MAX.
NOTE2:
A = Settemp(NOTE2) + SET VENTILATION PAGE VENT1.
B = Settemp(NOTE2) + SET VENTILATION PAGE VENT2.
C = Settemp(NOTE2) + SET VENTILATION PAGE VENT3.
D = Settemp(NOTE2) + SET VENTILATION PAGE VENT4.
E = Settemp(NOTE2) + SET VENTILATION PAGE VENT5.
F = Settemp(NOTE2) + SET VENTILATION PAGE VENT6.
G = Settemp(NOTE2) + SET VENTILATION PAGE VENT7.
H = Settemp(NOTE2) + SET VENTILATION PAGE VENT8.
C.HYS
OFF
House [°C]
OFF
C.HYS
FANS
FAN3
FAN4
FAN5
FAN6
FAN7
FAN8
C.HYS
F.HYS
F.HYS
F.HYS
F.HYS
F.HYS
FAN2
FAN2
FAN ANALOG
OUTPUT(VZ)
Min. Vent.
(NOTE1)
House [°C]
5.0
F.HYS
Min. Vent.
(NOTE1)
5.0
C.HYS
0.0
House [°C]
0.0
C.HYS
10.0
10.0
FAN ANALOG
OUTPUT(VZ)
A (NOTE2)
B (NOTE2)
C (NOTE2)
Settemp
(NOTE1)
SET VENTILATION PAGE FAN ANALOG: BASIC
A (NOTE2)
B (NOTE2)
C (NOTE2)
Settemp
(NOTE1)
SET VENTILATION PAGE FAN ANALOG: BASIC
A (NOTE2)
B (NOTE2)
C (NOTE2)
Settemp
(NOTE1)