EMKO EPC-1 - 6.4.15 NH3;CO2

MIN PPM: Min ppm value that can be read by Nh3 sensor (Range: 0 - 100 / Factory Setting: 0).
SAVE MIN: Parameter to save voltage for min PPM. (Range: NO- YES / Factory Setting: NO).
MAX PPM: Min ppm value that can be read by NH3 sensor (Range: 0 - 100 / Factory Setting: 0).
SAVE MAX: Parameter to save voltage for min PPM. (Range: NO- YES / Factory Setting: NO).
NH3 CALIBRATION
MIN PPM : NO
SAVE MIN: 0 PPM
MAX PPM : 100 PPM
SAVE MAX: NO
100PPM
6.4.15.1 NH3 CALIBRATION
6.4.15 NH3/CO2
80
MIN PPM: Min ppm value that can be read by CO2 sensor (Range: 0 - 100 / Factory Setting: 0).
SAVE MIN: Parameter to save voltage for min PPM. (Range: NO- YES / Factory Setting: NO).
MAX PPM: Min ppm value that can be read by CO2 sensor (Range: 0 - 100 / Factory Setting: 0).
SAVE MAX: Parameter to save voltage for min PPM. (Range: NO- YES / Factory Setting: NO).
NH3 CALIBRATION
MIN PPM : NO
SAVE MIN: 0 PPM
MAX PPM : 100 PPM
SAVE MAX: NO
100PPM
6.4.15.2 CO2 CALIBRATION
NH3 SET: NH3 set value (Range: 0 - 5000 / Factory Setting: 0).
NH3 HYS: NH3 hysteresis value (Range: 0 -1000 / Factory Setting: 6).
NH3 FCT: Increament factor of ventilation for over NH3 (Range: 0 - 8%00 / Factory Setting: 1%00).
CO2 SET: CO2 set value (Range: 0 - 5000 / Factory Setting: 0).
CO2 HYS: CO2 hysteresis value (Range: 0 -1000 / Factory Setting: 60).
CO2 FCT: Increament factor of ventilation for over CO2 (Range: 0 - 8%00 / Factory Setting: 1%00).
NH3/CO2 SET VALUES
NH3 SET : 60
NH3 HYS : 6
NH3 FCT : 1%00
CO2 SET : 300
CO2 HYS : 60
CO2 FCT : 1%00
6.4.15.3 NH3/CO2 SET VALUES