EMS SmartCell User Manual

©2020 EMS Ltd. All rights reserved Page 13 of 36 MK349-0001-99 (Issue 1) 22/10/2020 AJM
FAULT
NC C NO
FIRE
NC C NO
ACTIVE ACTIVE
FAULT FAULT
INPUT1 INPUT2
A B A B
BAT
ENABLE
TAMPER
RESET
ANTENNA A ANTENNA B
ATTENTION
ELECTROSTATIC
SENSITIVE DEVICE
RS232
EN54-4 UNIVERSAL PSU
SC-60-1000
INPUT: 220-240VAC, 50Hz, 0.3A
OUTPUT: 5.0-8.5VDC, 0.8A MAX
STATUS
FAULT
MAINS / CHARGER FAIL
BATTERY LOW
BATTERY FAIL
START
INPUT
L N
For additional information refer to TSD042
0359-CPR-00267
15 0905
SLIDE TO
REMOVE
OUTPUT: 5.0-8.5VDC, 0.8A MAX
INPUT
L N
For additional information refer to TSD042
0359-CPR-00267
15 0905
24 VDC dual
output PSU
- +
24V Out
OUTPUT 1
N/C C N/O
Fault
- +
24V Out
N/C C N/O
Fault
OUTPUT 2
Mains power connections
230 VAC WZMs only.
Connect both
power inputs.
There are also
general fault
inputs (GEN
FAULT) and mains
fault (M FAULT)
available.
The fault inputs
are NC and voltage
free.
If a fault input
(GEN FAULT or M
FAULT) is not being
used, leave the link
as factory fitted.
24 VDC power connections
24 VDC WZMs only.
Earth wire
Neutral wire
Live wire
220 to
240 VAC
mains
input
*
Additional mains
fault input
DC
POWER
0V V+
M
FAULT
OV V+
GEN
FAULT
A B
1
DC
POWER
0V V+
M
FAULT
OV V+
GEN
FAULT
A B
2
FAULT
NC C NO
FIRE
NC C NO
ACTIVE ACTIVE
FAULT FAULT
INPUT1 INPUT2
A B A B
DC
POWER
0V V+
M
FAULT
A B
GEN
FAULT
A B
1
POWER
0V V+
GEN
FAULT
DC
POWER
0V V+
M
FAU LT
A B
GEN
FAU LT
A B
2
- +
24V Out
OUTPUT 1
N/C C N/O
Fault
OUTPUT 2
- +
24V Out
N/C C N/O
Fault
*
*
The 24 VDC SmartCell WZM is designed to be powered from 2x 24 VDC power
sources, to meet country specific requirements.
EOL
(+) (-) (+) (+) (-) (+) (-) (+) (-) (+) (+) (-)
SOUNDER A
L1 L1 L2 EOL ALARM L1 L1 L2
IN OUT RES IN OUT
ZONE
A
B
C
D
EOL
(+) (-) (+) (+) (-) (+) (-) (+) (-) (+) (+) (-)
SOUNDER A
L1 L1 L2 EOL ALARM L1 L1 L2
IN OUT RES IN OUT
ZONE
A
B
C
D

EMS SmartCell Specifications

General

Brand	EMS
Model	SmartCell
Category	Monitor
Language	English