©2020 EMS Ltd. All rights reserved Page 19 of 36 MK349-0001-99 (Issue 1) 22/10/2020 AJM
View System Status
Maintenance/Test
Device Options
WZM Settings
Add New Device
Remove Device
Edit Settings
Signal Level Test
At WZM
At Device Location
Configure Devices
Insert Batteries
Into Device
NOW
Add Fire Device ?
Sounder Detector
ID:001234
Add <Exit
New FIRE
Device Added
ID:001234
Address 01
Add Another
Device ?
Continue <Exit
Add devices to system
From access level 3 (as previously
shown on page 16), press the
button until the screen displays:
Press the button and the screen
will display:
Press the button and the screen
will display*:
Press the button and the screen
will display:
Insert the device’s batteries and the
screen will change to show:
Check that the device ident on-screen
matches the device ident shown on
the barcode label. Press to confirm,
or to cancel. If accepted, the screen
will display:
Followed by:
Either continue adding new devices (by
inserting batteries, or press until the
front screen is displayed.
* Refer to the ‘SmartCell Intelligent Wireless Zone Monitor
Programming Guide’ (MK067) for alternative programming methods.
To Next Page
Loading...
Need help?
General