©2020 EMS Ltd. All rights reserved Page 3 of 36 MK349-0001-99 (Issue 1) 22/10/2020 AJM
Introduction
This quick start guide will show you how to set up the SmartCell
Wireless Zone Monitor (WZM), for connection to either addressable or
conventional fire alarm systems. For advanced programming, refer to
the ‘SmartCell Wireless Zone Monitor Programming Guide’ (MK067).
Note: this quick start guide will cover the method of adding devices via
power-up. Refer to the programming guide for more information of
alternative methods.
Important notes
The installation must conform to applicable local
installation codes and should only be installed by a fully
trained competent person.
!
SmartCell devices contain electronics that may be
susceptible to damage from Electro Static Discharge (ESD).
Take appropriate precautions when handling electronic
boards.
The procedures outlined in this installation guide must be
carefully followed.
To ensure correct operation, products must be used within
the specified environmental operating conditions.
Always select an appropriate device type for the
application as per local codes of practice, or as advised by
a qualified professional.
To Next Page
Need help?
General