Configuration
parameters (cont.)
Parameter Description
Density Factor
For operating modes: "level linear" and "level cylinder" - applications with
media with a density not equal to 1 gm/cm³. The pressure is divided by
this factor before carrying out the linearization function. This ensures that
it is adapted to the material.
Creep Flow
Suppression
Only for operating mode: "square root function" (flow).
Entry is always in % of flow.
Suppresses the display on small flow rates.
Low Sensor
Calibration
Sets the low sensor calibration value.
High Sensor
Calibration
Sets the high sensor calibration value.
Low Sensor
Limit *
Lower range-limit of sensor (Unit selectable with "Select Pressure Unit")
High Sensor
Limit *
Upper range-limit of sensor (Unit selectable with "Select Pressure Unit")
Sensor Pressure
*
Sensor pressure (Unit selectable with "Select Pressure Unit")
Temperature Unit
Changes the temperature units. Options: °C, K,°F
Unbiased
Pressure *
Display of current pressure value without bias correction
Biased Pressure
*
Display of current pressure value with bias correction, (corresponds to the
parameter "Measured Value", when the operating mode is set to "linear"
(pressure)).
Security Locking
Software write lock for the parameters: a number ≠ 130 locks the
parameter, 130 unlocks the parameter, see Chapters 5.5 and 6.6.
Serial-No.
SENS. *
Display of the sensor serial number
Process
Conn. P+
Material of process connection + side
Process
Conn. P–
Material of process connection – side
Gasket
Material of seal
Process
Diaphram.
Material of diaphragm
Fill Liquid
Oil filling
* Display value
Cerabar S FF 3 Foundation Fieldbus Interface
Endress+Hauser 23
To Next Page
Loading...
