Endress+Hauser Deltabar S PMD75 - Page 193

Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus Parameter description (Local operation and FieldCare)
Endress+Hauser 193
TOT. 1 USER UNIT (627)
Entry
Enter text (unit) for customer-specific unit for totalizer 1.
You can enter a maximum of eight alphanumeric characters here. → See also FACT.
U.U.TOTAL.1.
Prerequisite:
• TOTALIZER 1 UNIT = User unit
!
Note!
Only the first five characters are shown on the local operation. For example, if the
customer-specific unit "crates" was selected, only "crate" would be displayed.
If the unit contains a slash, up to eight characters can be shown on the local operation.
The maximum number of characters in the counter is again limited to five. For example if
the customer-specific unit "crates/m2" was selected, "crate/m2" would be displayed.
FieldCare accepts units with eight characters at most. The slash counts as one character.
Factory setting:
_ _ _ _ _ _ _ _
FACT. U.U. TOTAL. 1: (329)
Entry
Enter the conversion factor for a customer-specific unit for totalizer 1.
The conversion factor must be entered in relation to an appropriate SI unit, e.g. m
3
for the
"Volume operat. cond." FLOW-MEAS. TYPE. → See also TOT. 1 USER UNIT.
Prerequisite:
• TOTALIZER 1 UNIT = User unit
Example: You want the measured value to be displayed in "buckets".
– MEASURED VALUE =1 m3 i 100 buckets
– Entry TOT. 1 USER UNIT: bucket
– Enter FACT. U.U. TOTAL. 1: 100
– Result: MEASURED VALUE = 100 buckets
Factory setting:
1.0
NEG. FLOW TOT. 1 (400)
Selection
Specify the way of counting negative flows for totalizer 1.
P01-xMD7xxxx-16-xx-xx-en-003
Factory setting:
Inc. on neg. flow
RESET TOTALIZER1 (331)
Selection
You reset totalizer 1 to zero with this parameter.
Options:
• Abort (do not reset)
•Reset
Factory setting:
Abort
TOTALIZER 2 UNIT
(399), (663), (665), (667)
Selection
Select the unit for totalizer 2.
→ See also TOTAL 1. UNIT.
The index depends on the FLOW-MEAS. TYPE selected:
– Index 103: TOTALIZER 2 UNIT (general)
– Index 157 (399): FLOW-MEAS. TYPE "Volume operat. cond."
– Index 169 (663): FLOW-MEAS. TYPE "Mass"
– Index 171 (665): FLOW-MEAS. TYPE "Gas. std. cond."
– Index 173 (667): FLOW-MEAS. TYPE "Gas. norm cond."
Factory setting:
m
3
Table 20: OPERATING MENU → SETTINGS → TOTALIZER SETUP
Parameter name Description
Options
Stop on neg. flow
Dec. on neg. flow
Inc. on. neg. flow
negative flow
Total remains constant
Total decreases
Total increases
Total increases
Total increases
Total increases
positive flow