Endress+Hauser Deltabar S PMD75 - Page 194

Parameter description (Local operation and FieldCare) Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus
194 Endress+Hauser
P01-xMx7xxxx-19-xx-xx-en-014
Fig. 55: DISPLAY group
TOT. 2 USER UNIT (628)
Entry
Enter text (unit) for customer-specific unit for totalizer 2.
→ See also TOT. 1 USER UNIT.
Prerequisite:
• TOTALIZER 2 UNIT = User unit
Factory setting:
_ _ _ _ _ _ _ _
FACT. U.U. TOTAL 2 (330)
Selection
Enter the conversion factor for a customer-specific unit for totalizer 2.
→ See also FACT. U.U.TOTAL.1.
Prerequisite:
• TOTALIZER 2 UNIT = User unit
Factory setting:
1.0
NEG. FLOW TOT. 2 (416)
Selection
Specify the way of counting negative flows for totalizer 2.
→ See NEG. FLOW TOT. 1.
Factory setting:
Inc. on neg. flow
Table 20: OPERATING MENU → SETTINGS → TOTALIZER SETUP
Parameter name Description
MEASURED VALUE
QUICK SETUP
DISPLAYSETTINGS
OPERATING MENU
LANGUAGE
MENU DESCRIPTION
MAINDATA FORMAT
ALTERNATEDATA
DISPLAY CONTRAST
Table 21: OPERATING MENU → DISPLAY
Parameter name Description
MENU DESCRIPTOR (416)
Selection
Specify the contents for the main line of the local operation in the measuring mode.
→ See also Operating Instructions BA00301P (Deltabar S) and BA00302P (Cerabar S) or
BA00372P (Deltapilot S), "Local operation" section.
Options:
•Primary value (PV)
• Main measured value (%)
• Pressure
•Flow
• Level
• Tank content
•Temperature
• Error number
• Totalizer 1
• Totalizer 2
The selection depends on the measuring mode chosen.
Factory setting:
Primary value (PV)