Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus Parameter description (Local operation and FieldCare)
Endress+Hauser 195
MAIN DATA FORMAT (688)
Selection
Specify the number of places after the decimal point for the value displayed in the main
line.
→ See also Operating Instructions BA00301P (Deltabar S), BA00302P (Cerabar S) or
Deltapilot S (BA00372P), "Local operation" section.
Options:
•Auto
•x.x
•x.xx
•x.xxx
• x.xxxx
• x.xxxxx
Factory setting:
Auto
ALTERNATE DATA (423)
Selection
Switch on the "Alternating display" mode.
In this display mode, the local operation alternates between the following measured
values depending on the measuring mode selected.
– Pressure: primary value (PV) or main measured value (%) (MEASURED VALUE),
pressure (PRESSURE) and temperature (TEMP. SENSOR)
– Level: primary value (PV) or main measured value (%) (MEASURED VALUE), pressure
(PRESSURE) and temperature (TEMP. SENSOR)
– Flow: primary value (PV) or main measured value (%) (MEASURED VALUE), pressure
(PRESSURE), temperature (TEMP. SENSOR), totalizer 1 (TOTALIZER 1) and totalizer
2 (TOTALIZER 2)
Options:
•Off
•On
Factory setting:
Off
LANGUAGE
Selection
Select the menu language for the local operation.
!
Note!
• In local operation, the LANGUAGE parameter is arranged directly under the GROUP
SELECTION (menu path: GROUP SELECTION → LANGUAGE, → ä 133).
• Select the menu language for FieldCare using the "Language Button" in the
configuration window. Select the menu language for the FieldCare frame via the
"Extra" menu → "Options" → "Display" → "Language".
Options:
•Deutsch
• English
• Français
•Español
• Chinese (CHS)
• Japanese (JPN)
Factory setting:
English
DISPLAY CONTRAST (339)
Entry
Adjust contrast of local operation.
You specify the contrast of the display with a number. Changes are only accepted as single
steps, i.e. to change the value from "8" to "4", you need to save four times. You can also
adjust the contrast of the display by means of the keys on the electronic insert or at the
device.
→ See also Operating Instructions BA00301P (Deltabar S) and BA00302P (Cerabar S) or
BA00372P (Deltapilot S), "Function of the operating keys" section.
Input range:
4 to 13, 4: contrast weaker (brighter), 13: contrast stronger (darker).
Factory setting:
8
Table 21: OPERATING MENU → DISPLAY
Parameter name Description
To Next Page
Loading...
