M
moralesjamesSep 4, 2025
What to do if the Endress+Hauser Gammapilot FMG50 firmware is incompatible?
- MMiguel OconnorSep 5, 2025
Check software. Flash or change main electronic module.
What to do if the Endress+Hauser Gammapilot FMG50 firmware is incompatible?
Check software. Flash or change main electronic module.
What to do if the Endress+Hauser Measuring Instruments module is incompatible?
Check if correct electronic module is plugged. Replace electronic module.
What to do if the Endress+Hauser Measuring Instruments main electronics are defective?
Replace main electronics.
What to do if the Endress+Hauser Gammapilot FMG50 main electronics are faulty?
Restart device. Contact service.
What to do if the Endress+Hauser Gammapilot FMG50 Measuring Instruments memory content is inconsistent?
Transfer data or reset device. Contact service.
What to do if the Endress+Hauser Gammapilot FMG50 Measuring Instruments current output is out of range?
Check process. Check current output settings.
Measuring Principle | Gamma radiation |
---|---|
Housing Material | Aluminum or Stainless steel |
Application | Level measurement in liquids and bulk solids |
Process Temperature | -40 to +80 °C |
Process Pressure | Up to 40 bar |
Output Signal | 4-20 mA, HART |
Protection Class | IP66 |
Communication | HART |
Certificates/Approvals | ATEX, IECEx |
Ambient Temperature | -40 to +60 °C (-40 to +140 °F) |