6 Commissioning Temperature head transmitter
42 Endress+Hauser
2. Using “Matrix Parameter” the function group can be selected (e.g. basic
calibration) and then followed by the required function, e.g. “Sensor input”.
3. Enter numeric values or change settings. Then acknowledge using the F4 "Entry"
function key.
4. "SEND" appears when operating the F2 function key. Once the F2 key has been
operated all values entered in the hand module are transmitted to the TMT 182
measurement system.
5. A return to the "Online" menu level is made using the F3 "HOME" function key. Here,
the actual transmitter values measured with the new settings can be read.
Fig. 6-1: Configuration at the hand module example "Sensor input"
HART
®
function matrix
Fig. 6-2: HART
®
function matrix
R09-TMT182ZZ-02-06-xx-en-002.eps
R09-TMT182ZZ-02-06-xx-en-001.eps
To Next Page
Loading...
