Endress+Hauser iTEMP HART TMT 182 - Maintenance; PC Configuration Software ReadWin 2000; Interactive Setup of the Temperature Transmitter

7 Maintenance Temperature head transmitter
48 Endress+Hauser
6.2.4 Configuration using HART
®
-protocol and ReadWin
®
2000
PC configuration software ReadWin
®
2000
The configuration of the head transmitter can be done using both the HART
®
-protocol
and the ReadWin
®
2000 configuration software. The following table shows the structure
of the interactive menu led operation of ReadWin
®
2000.
For detailed ReadWin
®
2000 operating instructions please read the on-line
documentation contained in the ReadWin
®
2000 software. ReadWin
®
2000 can be
downloaded free of charge from the Internet on the following address:
• www.endress.com/Readwin
Interactive setting up of the temperature transmitter
Customer specific linearisation and sensor matching is done using the
SMC32.exe
(
Sensor Matching Calibration) configuration software. The PC configuration software
ReadWin
®
2000 and the SMC32.exe programme are available for a free of charge
download under the address
www.endress.com/Readwin. The SMC32.exe programme
calculates the linearisation coefficients X0 to X4, that need to be entered into the HART
®
transmitter in the COMMUWIN II operating matrix, the DXR 275 HART
®
hand held
operating unit or in ReadWin
®
2000.
2
Hint!
Integration into the ReadWin
®
2000 PC configuration programme of both the
SMC32.exe programme and a Quick set up under which all parameters can be seen at
a glance is planned.
7Maintenance
Maintenance The head transmitter is maintenance-free.
Configurable parameters (Unit function description see s. chapter 6.2.3)
Standard settings – Type of sensor
– Connection mode (2-,3-, or 4-wire connection on RTD)
– Units (°C, °F or K)
– Measurement range start value
– Measurement range end value
– Coefficient X0 to X4 (on sensor type polynom RTD/TC)
– Temp.-compensation (on sensor type polynom TC)
Expanded settings – Cold junction compensation internal/external (on TC)
– Temperature external (on TC with cold junction compensation
external)
– Cable resistance compensation (on RTD 2-wire connection)
– Fault condition reaction
– Output (4 to 20 mA/20 to 4 mA)
– Damping (filter)
– Offset
– TAG (Measurement point description)
– Identifier (Descriptor)
Service functions – Simulation (on/off)
– Reset/factory default
– Series number (only display)
– Operation code (=release code 281)