Endress+Hauser Levelflex M FMP41C - Function Ackn. Alarm (017); Function Overspill Prot. (018); Function Broken Probe Det (019)

Levelflex M 4 Function group "safety settings" (01)
Endress+Hauser 31
4.8 Function "ackn. alarm" (017)
This function acknowledges an alarm in case of "self holding".
Selection:
•no
• yes
no
The alarm is not acknowledged.
yes
Acknowledgement takes place.
4.9 Function "overspill prot." (018)
When "german WHG" is selected, various parameters relating to WHG overflow protection are
defaulted and the instrument is locked against further operation. Select "Standard" to unlock, the
WHG parameter settings are retained.
4.10 Function "broken probe det" (019)
This function activates the automatic recognition of broken probes.
Before updating the broken probe detection a mapping must be performed (function "range of
mapping" (052) and "start mapping" (053)).
Selection:
•off
•on
⇒
ENDRESS + HAUSER
E
+
–
⇒
ENDRESS + HAUSER
E
+
–
⇒
ENDRESS + HAUSER
E
+
–
⇒
⇓
After 3 s, the following message appears
ENDRESS + HAUSER
E
+
–