6 Function group "linearisation" (04) Levelflex M
38 Endress+Hauser
semi-automatic
The tank is filled in stages when the linearisation curve is entered semi-automatically. The Levelflex
automatically detects the level and the corresponding volume/weight has to be entered.
The procedure is similar to manual table entry, where the level value for each table point is given
automatically by the instrument.
!
Note!
If the tank is emptied, pay attention to the following points:
• The number of points must be known in advance.
• The first table number = (32 - number of points).
•Entries in "Tab. no." (043) are made in reverse order (last entry = 1).
table on
An entered linearisation table only becomes effective when activated.
clear table
Before making entries into the linearisation table, any existing tables must be deleted. The lineari-
sation mode automatically switches to linear.
!
Note!
A linearisation table can be deactivated by selecting "linear" or "horizontal cyl" (or the
"level/ullage" (040) function = "level DU", "ullage DU"). It is not deleted and can be reactivated
at any time by selecting "table on".
6.3 Function "customer unit" (042)
You can select the customer unit with this function.
Selection:
•%
•l
•hl
•m3
•dm3
•cm3
•ft3
•us_gal
•i_gal
•kg
•t
•lb
•ton
•m
•ft
•mm
•inch
Dependence
The units of the following parameters are changed:
• measured value (000)
• input volume (045)
• max. scale (046)
• simulation value (066)
⇒
ENDRESS + HAUSER
E
+
–
To Next Page
Loading...
