Endress+Hauser Levelflex M FMP41C - Function Group Linearisation (04); Function Level;Ullage (040)

6 Function group "linearisation" (04) Levelflex M
34 Endress+Hauser
6 Function group "linearisation" (04)
6.1 Function "level/ullage" (040)
Selection:
• level CU
• level DU
• ullage CU
• ullage DU
level CU
Level in customer units. The measured value can be linearised.
The "linearisation" (041) default value is set to a linear 0...100%.
level DU
Level in the selected "distance unit" (0C5).
ullage CU
Ullage in customer units. The value can be linearised.
The "linearisation" (041) default value is set to a linear 0...100%.
ullage DU
Ullage in the selected "distance unit" (0C5).
!
Note!
Reference point for the ullage is "full calibr." (006) (=span).
⇒
ENDRESS + HAUSER
E
+
–
⇒
ENDRESS + HAUSER
E
+
–