Endress+Hauser Levelflex M FMP41C - Function Serial No. (0 C4); Function Device ID (0 C4); FOUNDATION Fieldbus Only; Function Distance Unit (0 C5)

12 Function group "system parameters" (0C) Levelflex M
70 Endress+Hauser
12.5 Function "serial no." (0C4)
This function displays the instrument serial number.
12.6 Function "device id" (0C4), FOUNDATION
Fieldbus only
This function displays the instrument serial number.
12.7 Function "distance unit" (0C5)
You can select the basic distance unit with this function.
Selection:
•m
•ft
•mm
•inch
Dependence
m, mm: "format display" (094) can only be "decimal".
The units are changed for the following parameters:
• empty calibr. (005)
• full calibr. (006)
• safety distance (015)
• input level (044)
• diameter vessel (047)
• range of mapping (052)
• cust. tank map (055)
• offset (057)
• simulation value (066)
•measureddist. (0A5)
• measured level(0A6)
⇒
ENDRESS + HAUSER
E
+
–
⇒
ENDRESS + HAUSER
E
+
–