Endress+Hauser Liquiphant FTL64 - Installation Specifics; Pipe Installation and Fork Alignment; Device Screwing and Torque Specifications

Liquiphant FTL64 HART Mounting
Endress+Hauser 17
Installing in pipes
• Flow velocity up to 5 m/s with a viscosity of 1 mPa⋅s and density of 1 g/cm
3
(SGU).
Check for correct functioning in the event of other process medium conditions.
• The flow will not be significantly impeded if the tuning fork is correctly aligned and the
marking is pointing in the direction of flow.
• The marking is visible when installed.
A0034851
 12 Installation in pipes (take fork position and marking into consideration)
Screwing in the device
• Turn by the hex bolt only, 15 to 30 Nm (11 to 22 lbf ft)
• Do not turn at the housing!
1.
2.
A0042423
 13 Screwing in the device