Endress+Hauser Liquiphant FTL64 - Output and Alarm Behavior; Alarm Signals, Load, Damping, and Switch Outputs

Liquiphant FTL64 HART Technical data
Endress+Hauser 55
15.2.3 Load
U – 10.5 V
23 mA
[ ]W
10.5
3530
1065
848
£
U
[V]
1
2
R
L max
3
R
L max
A0039232
 33 Load 4 to 20 mA HART
1 Power supply 10.5 to 30 V
DC
Ex i
2 Power supply 10.5 to 35 V
DC
, for other types of protection and for non-certified device versions
3 R
Lmax
maximum load resistance
U Supply voltage
Operation via handheld terminal or PC with operating program: take minimum
communication resistance of 250 Ω into consideration.
15.2.4 Damping
Damping affects all the outputs (output signal, display) and is only available in the
continuous 4 to 20 mA mode.
Damping has no effect on the SIO.
Activating damping:
Via local display, Bluetooth, handheld terminal or PC with operating program, continuous
from 0 to 999 s
Factory setting: 1 s
15.2.5 Switch output
Preset switching delay times can be ordered:
• 0.5 s when the tuning fork is covered and 1.0 s when the tuning fork is uncovered
(factory setting)
• 0.25 s when the tuning fork is covered and 0.25 s when the tuning fork is uncovered
(fastest setting)
• 1.5 s when the tuning fork is covered and 1.5 s when the tuning fork is uncovered
• 5.0 s when the tuning fork is covered and 5.0 s when the tuning fork is uncovered
The user can also set the switching delays for when the fork is covered and uncovered
in the range from 1 to 60 seconds independently of one another.
(Operation via display, Bluetooth or FieldCare, DeviceCare, AMS, PDM)
15.2.6 Ex connection data
See safety instructions (XA): All data relating to explosion protection are provided in
separate Ex documentation and are available from the Downloads Area of the
Endress+Hauser-website. The Ex documentation is supplied as standard with all Ex
devices.