Endress+Hauser Liquistation CSF34 - Page 110

Operation Liquistation CSF34
110 Endress+Hauser
Menu/Setup/Sampling programs
Function Options Info
Activation input Selection
• No program part start input
configured
• Binary input S:x
Factory setting
No program part start input
configured
Select the input for start of the subprogram.
The binary input must be configured for this
function. Only the configured inputs are
displayed.
Having selected Activation input PROFIBUS DPor Modbus:
Activation signal Selection
• None
• PROFIBUS AO 0x
Factory setting
Enable subprogram via fieldbus.
Sample at enable
(not for single sample
and sampling table and
also not for "Immediate"
and event)
Selection
• Yes
• No
Factory setting
Yes
Specify whether the first sample should be
taken directly when the subprogram is
enabled. For example, with intervals, a
sample is taken at the start of every
activation interval.
Sample at disable Selection
• Yes
• No
Factory setting
No
Specify whether a sample should be taken
when the subprogram is disabled. For
example, with intervals, a sample is taken at
the end of every activation interval.
Deactivation Selection
• Bottles full
• Enable invalid
• Deactivation with event
Factory setting
Enable invalid
Select the disable function of the
subprogram:
Bottles full
The subprogram is disabled once all the
assigned bottles have been filled.
Enable invalid
Disable via limit value
Deactivation with event
New parameter can be defined
Bottle change mode Selection
• No
• Yes
Factory setting
Yes
No
The bottle is changed following a disable/
enable
Yes
When the cycle is finished, the system
continues filling the last bottle.
Synchronize samplings Selection
• To subprogram start
• To clock
Factory setting
To subprogram start
The intervals defined in the sampling mode
are enabled when the subprogram is started.
To clock
The intervals defined in the sampling mode
are enabled after a specific time. For
example, if 30 min is entered this means
that the interval is only activated at a time of
xx:30.
--> You configure this time in the ""Offset
synchronization menu item.