The "Expert" menu Micropilot FMR50/FMR51/FMR52/FMR53/FMR54/FMR56/FMR57 FOUNDATION Fieldbus
106 Endress+Hauser
Selection • No
The map is not recorded. The device quits the sequence ("End of sequence" is displayed).
• Record map
The map is recorded. When the recording is completed, the new measured distance and
the new mapping range appear on the display. These values must be confirmed by
pressing . The device quits the sequence. ("End of sequence" is displayed.)
• Overlay map
The new map is generated by overlaying the existing map by the envelope curves taken
from the period defined in the Mapping overlay time parameter.
• Factory map
The map permanently stored in the device is used.
• Delete partial map
The map is deleted between the points defined by Mapping start point and Mapping
end point.
Factory setting No
End of mapping (1224)
Navigation Expert → Sensor → Mapping → End of mapping
Write access Maintenance
Description Defines the behavior of the map at within the defined Map gap.
Options • Adjustable (0 ... 342)
• Last map value
Factory setting Adjustable (342)
End mapping amplitude (1109)
Navigation Expert → Sensor → Mapping → End map. ampl.
Write access Maintenance
Description Amplitude of the map within the Map gap
Input range –99 999 to 99 999 dB
Factory setting –90 dB
To Next Page
Loading...
