Endress+Hauser Micropilot FMR56 - Page 28

The "Expert" menu Micropilot FMR50/FMR51/FMR52/FMR53/FMR54/FMR56/FMR57 FOUNDATION Fieldbus
28 Endress+Hauser
Factory setting . (point)
Number format (0099)
Navigation Expert → System → Display → Number format
Write access Maintenance
Description Choose number format for the display
Options • Decimal
• ft-in-1/16" (Only valid for distance units)
Factory setting Decimal
Decimal places menu (0573)
Navigation Expert → System → Display → Decimal places menu
Write access Maintenance
Description Select number of decimal places for the representation of numbers within the operating
menu.
Options • x
• x.x
• x.xx
• x.xxx
• x.xxxx
Factory setting x.xxxx
Additional information This parameter only determines the representation of numbers within the operating menu
(e.g. Empty calibration, Full calibration). It does not affect the measured value
representation.
For measured values, the number of decimal places is defined in the Decimal places 1 to
Decimal places 4 parameters (→  25).
This setting does not affect the measurement and calculation accuracy of the device.
Contrast display (0105)
Navigation Expert → System → Display → Contrast display
Write access Operator
Description Adjust local display contrast setting to ambient conditions (e.g. lighting or reading angle).