Endress+Hauser Proline Promag 10 - Device Functions to be Configured During Commissioning

Commissioning Proline Promag 10
44 Endress+Hauser
4.4 Device functions to be configured during commissioning
Check the values and settings of the device functions not marked gray in the following function
matrix (UNIT VOL. FLOW, UNIT VOLUME, LANGUAGE, CURRENT RANGE etc.) and adapt them
to your application.
A complete description of all the device functions is provided in the Operating Instructions on
the CD-ROM.
Group Functions
SYSTEM
UNITS
 UNIT
VOL. FLOW
UNIT
VOLUME
FORMAT
DATE/TIME
OPERATION  LANGUAGE ACCESS
CODE
DEFINE PRIV.
CODE
USER
INTERFACE
 FORMAT CONTRAST
LCD
TEST
DISPLAY
TOTALIZER  SUM OVERFLOW RESET
TOTALIZER
CURRENT
OUTPUT
 CURRENT
RANGE
VALUE
20 mA
TIME
CONSTANT
PULSE/
STATUS OUTP.
 OPERATING
MODE
PULSE
VALUE
PULSE
WIDTH
OUTPUT
SIGNAL
ASSIGN
STATUS
SWITCH-ON
POINT
SWITCH-OFF
POINT
COMMUNICA-
TION
 TAG
NAME
TAG
DESCR.
BUS
ADDRESS
HART WRITE
PROTECT.
MANUFAC-
TURER ID
DEVICE
ID
PROCESS
PARAM.
 LOW FLOW
CUT OFF
EPD EPD ADJ.
SYSTEM
PARAM.
 INSTALL.
DIRECTION
MEASURING
MODE
POS.
ZERO-RET.
SYSTEM
DAMP.
SENSOR
DATA
 CALIBRAT.
DATE
K-FACTOR ZERO POINT NOMINAL
DIAMETER
MEASURING
PERIOD
EPD
ELECTRODE
SUPERVISION  FAILSAFE
MODE
ALARM
DELAY
SYSTEM
RESET
SELF
CHECKING
SIMULAT.
SYSTEM
 SIM.
FAILSAFE
SIM.
MEASURAN
D
VALUE SIM.
MEASURAN
D
SENSOR
VERSION
 SERIAL-
NUMBER
SENSOR
TYPE
AMPLIFIER
VERS.
 SW REV.