Endress+Hauser Proline Promag 300 - Page 23

Proline Promag 300 HART Commissioning (installation and configuration)
Endress+Hauser 23
NOTICE
If the measuring device has been set to the Mass flow option measured variable, the
Assign current output in the SIL confirmation sequence is automatically changed to
Volume flow option.
The 4 mA value and 20 mA value are reset to the factory setting.
‣
Cancel the SIL confirmation sequence.
‣
Check the settings of the current output and change them if necessary.
Setup
Current output 1
Assign
current output
=
Volume flow
A0025650-EN
Simulation
=
Off
Diagnostics
Simulation
current output 1
=
Off
Assign
process variable
A0021506-EN