Endress+Hauser Proline Promag 300 - Page 24

Commissioning (installation and configuration) Proline Promag 300 HART
24 Endress+Hauser
Sensor
Process
parameter
Empty pipe
detection
Flow
override
=
Off
Expert
=
Off
A0031507-EN
The diagnostic behavior is set in such a way that the measuring device is set to the safe state
when an error occurs. This means that the diagnostic messages listed in the graphic are set to
alarm and the current output adopts the configured failsafe mode .
System
Diagnostic
behavior
Diagnostic
handling
=
Alarm
Expert
Diagnostic no.
832, 833
Diagnostic no.
881
Diagnostic no.
953
Diagnostic no.
124, 125
Diagnostic no.
834, 835
A0043167-EN
• 124 Relative signal strength
• 125 Relative sound velocity
• 832 Electronics temperature too high