Proline Promag W 800
Endress+Hauser 51
Config 5800 operating tool Config 5800 is a software operating tool which is used to configure and operate the Promag 800 measuring
device. The measuring device does not support any other operating tools.
Function scope
• Access to all the measuring device parameters:
– Via the user interface integrated in the operating tool
– Via the parameter menu
• Configuring/establishing measuring device communication via GSM, mail etc.
These parameters are only available via the parameter menu of the operating tool.
• Operation of the measuring device.
• Saving or exporting data records (parameters, events etc.).
• Saving or loading the configuration of the measuring device.
• Saving data or reading out data from the data logger.
The FXA 291 service interface (USB version) is required to connect the computer to the
measuring device. The FXA 291 service interface is not included in the scope of supply (accessory
ä 53).
Remote operation • Via Config 5800 operating tool
• Via GSM (Global System for Mobile Communication)/GPRS (General Packet Radio Service)
Languages English, German, Italian, Spanish, French
Certificates and approvals
CE mark The measuring system is in conformity with the statutory requirements of the applicable EC Directives.
These are listed in the corresponding EC Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
Drinking water approval • WRAS BS 6920
•ACS
• NSF 61
• KTW/W270
Other standards and
guidelines
• EN 60529: Degrees of protection provided by enclosures (IP code)
• EN 61010-1: Safety requirements for electrical equipment for measurement, control and laboratory use
• IEC/EN 61326: Emission in accordance with Class A requirements
GSM approvals • EN 301 511 V9.0.2
Global System for Mobile communications (GSM); Harmonized EN for mobile stations in the GSM 900 and
GSM 1800 bands covering essential requirements under article 3.2 of the R&TTE directive (1999/5/EC)
• EN 301 489-7 V1.3.1
Electromagnetic compatibility and Radio spectrum Matters (ERM);
ElectroMagnetic Compatibility (EMC) standard for radio equipment and services;
Part 7: Specific conditions for mobile and portable radio ans ancillary equipment of digital cellular radio
telecommunications systems (GMS and DCS)
• EN 61326
Electrical equipment for measurement, control and laboratory use
EMC requirements - Part 1: General requirements
• EN 60950-1:2006 + A11: 2009 + A1:2010 + A12: 2011
Information technology equipment - Safety - Part 1: General requirements
• 47CFR15 (12/2010) Part 15
RADIO FREQUENCY DEVICES, Subpart B - Unintentional Radiators
To Next Page
Loading...
