Endress+Hauser Proline Promag W 800 - Ordering Information; Accessories; Device-Specific Accessories; Communication-Specific Accessories

Proline Promag W 800
Endress+Hauser 53
Ordering information
Detailed ordering information is available from the following sources:
• In the Product Configurator on the Endress+Hauser website: www.endress.com
 Select country  Instruments  Select device Product page function: Configure this product
• From your Endress+Hauser Sales Center: www.endress.com/worldwide
Product Configurator - the tool for individual product configuration
• Up-to-the-minute configuration data
• Depending on the device: Direct input of measuring point-specific information such as measuring range or
operating language
• Automatic verification of exclusion criteria
• Automatic creation of the order code and its breakdown in PDF or Excel output format
• Ability to order directly in the Endress+Hauser Online Shop
Accessories
Various accessories, which can be ordered with the device or subsequently from Endress+Hauser, are available
for the device. Detailed information on the order code in question is available from your local Endress+Hauser
Sales Center or on the product page of the Endress+Hauser website: www.endress.com.
Device-specific accessories For the transmitter
For the sensor
Communication-specific
accessories
Accessories Description
Display protection Is used to protect the display from impact or abrasion caused by sand in desert
areas.
Connecting cable for
Remote version
Coil and electrode cables, various lengths, reinforced cables available on request.
Ground cable Set, consisting of two ground cables for potential equalization.
Pipe mounting set Pipe mounting set for transmitter.
Conversion kit
compact  remote
For converting a compact device version to a remote device version.
Accessories Description
Ground disks for flange
connections
Are used to ground the fluid in lined measuring tubes to ensure
proper measurement.
For details, see Installation Instructions EA070D
Accessories Description
Commubox FXA291
(USB version)
Connects the measuring device to a computer with the
Config5800 software operating tool installed:
• Configuration of the measuring device for establishing GSM/GPRS communication
(only possible using the Config5800 software operating tool)
• Saving data or reading out data from the data logger.