Endress+Hauser Proline Promag W 800 - Mounting procedure; Mounting requirements

Proline Promag W 800
22 Endress+Hauser
For permanent immersion in water
A fully welded remote version of the Promag W with IP68 protection is optionally available for
permanent immersion in water to a depth of  3 m (10 ft). The measuring device satisfies diverse
corrosion protection categories in accordance with EN ISO 12944. The fully welded design along with
the connection compartment sealing system ensure that moisture cannot enter the measuring device.
The connecting cables of the remote version can be ordered:
• With pre-terminated cables that are already connected to the sensor.
• Optionally: With pre-terminated cables, where the cables are connected by the customer onsite (incl. tools
for sealing the connection compartment).
A0017296
Installation for permanent immersion in water
For buried applications
A remote version of the Promag W with IP68 protection is optionally available for buried applications.
The measuring device satisfies the certified corrosion protection Im3 in accordance with EN ISO 12944. It can
be used directly underground without the need for additional protective measures. The device is installed in
accordance with the usual regional installation regulations (e.g. EN DIN 1610).
The connecting cables of the remote version can be ordered:
• With pre-terminated cables that are already connected to the sensor.
• Optionally: With pre-terminated cables, where the cables are connected by the customer onsite (incl. tools
for sealing the connection compartment).
A0017298
Installation for buried applications
Orientation The direction of the arrow on the sensor nameplate helps to match the sensor with the direction of flow
(direction of fluid flow through the pipe).
An optimum orientation position helps avoid gas and air accumulations and deposits in the measuring
tube.
Vertical orientation
Vertical orientation is optimal in the following scenarios:
• For self-emptying piping systems.
££3 ( 10)
m (ft)