Proline Promag W 800
52 Endress+Hauser
Declaration of Conformity CE mark
The measuring system meets the requirements of EC Directive "Electromagnetic compatibility"
(EMC Directive).
• Interference emission: EN 61326: Class A, Industry
• Interference immunity: EN 61326: Industry
A Declaration of Conformity in line with the standards cited above has been submitted and can be
viewed at Endress+Hauser.
FCC information (Federal Communications Commission)
This device generates, uses and can radiate radio frequency energy, and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this device
does cause harmful interference to radio or television reception, which can be determined by turning
the device off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the device and receiver
• Connect the device to an outlet on a circuit different from that to which the receiver is connected.
To ensure that the device meets current FCC requirements and safety conditions, which restrict both
the maximum radio frequency output rating and human exposure to radio frequency radiation, use an
antenna with a maximum antenna gain of 2 dBi. Furthermore, a distance of at least 20 cm must be
observed between the device antenna and the user's body and everyone in the vicinity of the antenna.
This distance must be observed for all applications and uses.
Modifications
The FCC requires the manufacturer to inform users that all modifications made to this device, which
are not expressly approved by Endress+Hauser, can void the authority of the user to operate the device.
FCC statement (Federal Communications Commission)
This device complies with Part 15 of the FCC regulations.
Operation is subject to the following two conditions:
• This device cannot cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
Remarks regarding wireless equipment
The use of wireless devices can be restricted in certain situations or environments. Such restrictions can
apply in airplanes, vehicles, hospitals, in the vicinity of explosives, in hazardous areas etc. If you are
unsure which directive applies for the use of this device, request usage approval prior to switching on
the device.
Measuring device approval The measuring device is (optionally) approved as a cold water meter (MI-001) for volume
measurement in service subject to legal metrological control in accordance with the European
Measuring Instruments Directive 2004/22/EC (MID), type-examination certificate ATLab-I13-001.
The device is qualified to OIML R49 and has an OIML Certificate of Conformity (optional).
To Next Page
Loading...
