Endress+Hauser Proline Prosonic Flow B 200 - Page 58

Commissioning Proline Prosonic Flow B 200 HART
58 Endress+Hauser
10.4 Configuring the measuring device
The Setup menuwith its guided wizards contains all the parameters needed for standard
operation.
Navigation to the Setup menu
Overview of the wizards in the "Setup" menu

Setup
Device tag (0215)
→  59
‣
System units
→  59
‣
Medium selection
→  62
‣
Current input
→  63
‣
Current output 1 to 2
→  65
‣
Pulse/frequency/switch output
→  69
‣
Display
→  78
‣
Output conditioning
→  80
‣
Low flow cut off
→  82
‣
Advanced setup
→  84
10.4.1 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a
unique designation using the Device tag parameter and thus change the factory setting.
1
XXXXXXXXX
A0013375
 16 Header of the operational display with tag name
1 Device tag
The number of characters displayed depends on the characters used.
Entry of the tag name in the "FieldCare" operating tool →  50
Navigation
"Setup" menu → Device tag