12
© 2017 Energreen Srl
Professional machinery
DANGER:
DANGER OF EXPLOSION OR FIRE
During normal daily maintenance do not clean with high pressure water (pressure
washer) electrical components, such as:
• Receiver unit and remote control;
• Fuse box and relays;
• Engine control unit and the machine ECUs;
Put a guard or cover adequately before washing so as to isolate the electrical
components.
3.2 - GENERAL PRECAUTIONS
• It is mandatory to read and follow the instructions indicated in the use and maintenance manual
before performing any operation or manoeuvre with the machine. It is too late to do so while working.
Improper use or an incorrect manoeuvre can result in serious damage to persons or property;
• Operators and maintenance technicians must be very familiar with the machine, especially regarding
the dangers associated with misuse or making incorrect repairs.
• Before starting carry out all the checks on the tractor and equipment regarding:
- Operation;
- Accident prevention regulations;
- Guards.
• Even when the machine is being used correctly, stones or other things can be thrown a considerable
distance by the machine. Therefore, there must be nobody in the range of danger. Pay great
attention when working near roads or buildings;
• Before beginning a day’s work, always check the condition of the tools and all the guards. If they are
damaged or missing, replace them.
• Make sure that nobody can start the machine by mistake whilst the machine is being inspected or
repairs are being carried out. Do not wear loose clothing.
• Never accept passengers on the machine;
• Never carry persons on the ail head or on any equipment tted;.
• Never stand near the machine until the equipment is at completed standstill;
• Before starting the machine make sure that there are no people and/or animals around it;
• Work on at, rm ground, avoiding banks or slopes with steep gradients;
• Before leaving the machine unattended, proceed as follows:
1. Park the machine on a at surface.
2. Reduce the rpm of the engine before turning it off. Press the remote control red button and turn
the ignition key to the “O” position.
3. Remove the ignition key and take the remote control away with you.
• Replace any missing or worn warning plates or pictograms immediately.
• Never underrate or ignore safety regulations.
• Go to an authorised workshop if the safety devices are no working (e.g. dead man's brake, operator's
seat etc...)
• Keep the remote control out of the reach of unauthorised personnel and especially children.
To Next Page
Loading...