27
© 2017 Energreen Srl
Professional machinery
6 - USE OF MACHINE
6.1 - PRELIMINARY CHECKS
The operator must check that the machine has been supplied with the:
• Machine and equipment user manual
• Inspection log / coupons booklet
• Registration certicate (if requested)
• Third party liability insurance policy (if requested)
• Three-phase motor;
• Technical appendix;
If the machine is resold as a “second hand” machine, the customer / user must provide the purchaser
with the complete use and maintenance manual as well as the inspection log book.
6.2 - CHECKS TO PERFORM AT THE START OF EACH WORKING DAY
Carry out an external inspection of the machine (joints, hoses, hydraulic components, etc.) and check for
any leaks of oil or other liquids.
Check the rubber hoses and make sure there are no cuts, holes, wear, leaks etc.
Do not look for oil leakages with your bare hands or other parts of your body. Use
paper or rags to identify the leak.
Always wear waterproof gloves and safety goggles.
CAUTION:
6.2.1 - CHECKING THE CHROME-PLATED PARTS
Inspect the chrome-plated parts of the machine (cylinders) and make sure that they are not scored
or damaged. In the case of damage, replace.
6.2.2 - CHECKING THE SAFETY DEVICES
Verify that the safety devices installed on the machine (micro on seat and on the lever, horn,
beacon, lights) work properly.
In case one or more of the parts listed above malfunction or break; do not use the machine
and contact specialised personnel and report the problem.
WARNING:
To Next Page
Loading...