ENERGREEN RoboMAX - Cleaning or Replacing Air Filters

81
© 2017 Energreen Srl
Professional machinery
9.5.9 - CLEANING OR REPLACING AIR FILTERS
DANGER:
Remove the lter only with the engine off and do not start the engine with the air lter open.
Wear protective clothing when carrying out cleaning.
The air lter assembly consists of a primary large capacity cartridge and a safety cartridge. The primary
cartridge can be cleaned with a jet of air, but the safety cartridge must only be replaced. Whenever you
replace the primary cartridge, replace also the safety cartridge.
CAUTION:
To clean (daily) and replace (at 500 hours) the air lter assembly cartridges:
• Open the engine hood using the appropriate key.
• Open the two fastening clips (A). And remove the cover.
• Pull the primary cartridge (B) out. If it is difcult to remove, turn the cartridge slightly whilst
pulling it at the same time. Clean it with a jet of air or replace it.
A
C
B
• Pull the safety cartridge (C) out, if the extraction is difcult, make small rotation movements
and at the same time pull the cartridge, replace the safety cartridge every time the primary
cartridge is changed.
• Replace the cover and fasten it using the two hooks (A).
• Do not wash the air lter elements.
• Do not use solvents.
• Do no used compressed air, it could damage the cartridge.
• Do not oil the cartridges.
• When using compressed air for cleaning, pay attention when directing the jet of
air as it could damage the cartridge.
WARNING: