ENERGREEN RoboMAX - Receiver Unit; Gear Reduction Units

60
© 2017 Energreen Srl
Professional machinery
6.9.6 - RECEIVER UNIT
Malfunctions Causes Measures
The POWER LED is off. The receiving unit is off. Correctly couple the connecting plug
and power the receiver unit.
The POWER LED is on. The radio electric connection is
absent.
Bring the transmitter unit towards
the receiver unit.
The ALARM LED ashes once. There is an error on the STOP
outputs.
Correctly couple the connecting
plug.
Check the correct wiring of the
STOP outputs.
The ALARM LED ashes twice. There is an error on the SAFETY
outputs.
Correctly couple the connecting
plug.
Check the correct wiring of the
SAFETY outputs.
The ALARM LED ashes three
times.
The is an error on the outputs
relative to the direction commands.
Check the correct wiring of the
outputs relative to the direction
commands. Contact ENERGREEN
customer care
The ALARM LED is on. The receiver unit is not working
properly.
Contact ENERGREEN customer
care
The RUN LED is ashing The remote control unit is not
sending commands to the CAN
network.
Contact ENERGREEN customer
care
The ERR LED is ashing There is a CAN communication error Contact ENERGREEN customer
care
If the fault or the reason for it is not indicated in the list of faults shown in tables below, contact ENERGREEN in order for repairs to be carried out.
6.9.7 - GEAR REDUCTION UNITS
Malfunctions Cause Solution
Oil seeping from the seals Stiffening through being stored for
too long.
Clean the area and check in a day or
two
Damage or slight wear Apply to a customer care centre
Excessive amount of lubricant Checking the oil level
Vibrations and/or excessive nosiness Wheel gear reduction unit not in-
stalled properly
Apply to a customer care centre
Internal anomalies
Badly lubricated or defective bear-
ings
Teeth with bruises or chipping
Multiple disk parking brake cannot be
released
No pressure in the braking circuit. Check the brake connection
Bonding of the disks due to the
length of time parking.
Apply pressure to the brake and
make the wheel turn by activating the
engine.
Defective brake hold Apply to the customer care centre