69
© 2017 Energreen Srl
Professional machinery
8 - STORAGE
If the machine is stopped for long periods, it must be stored in a place protected from the elements
to prevent damage. Before storing the machine, it is recommended that you clean it thoroughly and
lubricate all mechanical components to protect them from rust. The machine should be stored at a
temperature between 0°C and 40°C.
Before storing the machine for long periods, you are recommended to perform the following steps:
• Free the equipment (e.g. the rotor and the tools) from any cutting or other residuals;
• Clean the machine carefully;
• Visually inspect the whole machine for structural damage or deep scratches on the paintwork. Make
sure that the original safety signs are still present in their proper positions and that they are integral
and legible;
• Grease all mechanical parts that are subject to friction, the locking pins and all machine parts that
are no longer covered with their original coating of paint in order to prevent rust from forming;
• If possible, store the machine in a covered area and on a at and rm surface;
• The machine must be stored with the equipment in the transport position;
• Make sure that the cabin is closed and that the controls are not accessible.
8.1 - DISMANTLING AND DECOMMISSIONING
Should you decide to no longer use the machine or part of it, it must be dismantled and decommissioned.
Before scrapping, the plastic/rubber parts and electrical and electronic materials must be separated.
Drain any used uids and dispose of them in a dump/recycling facility equipped to handle this product.
Carry out these operations according to the regulations in force.
If the machine or parts of it were decommissioned, all parts that could constitute a haz-
ard must be made safe.
WARNING:
• Remember that every time you change the oil, replace batteries, rubber pipes, tyres
and any other parts of the machine that should be disposed of separately, always
refer to current legislation regarding waste disposal.
• Take used hydraulic uid to a dump/recycling facility equipped to handle this prod-
uct.
WARNING:
To Next Page
Loading...