ENERGREEN RoboMAX - Starting with Auxiliary Battery

To Next Page

To Previous Page

Professional machinery

7.4 - STARTING THE ENGINE USING AN AUXILIARY BATTERY

If the engine has to be started using an external

battery, proceed as follows:

1. Remove the seven screws that fasten the

cover of the battery compartment (A) located

on the right-hand side and then remove it.

2. Connect a red terminal of the lead to the

positive terminal (+) of the battery and the

other end to the positive terminal (+) of the

auxiliary battery.

3. Connect a black terminal of the lead to the

negative terminal (-) of the battery and the

other end to the negative terminal (-) of the

auxiliary battery.

4. The engine can now be started using the

ignition key.

5. Bring the speed of the diesel engine to

1000 rpm and wait for a few minutes before

disconnecting the external battery.

WARNING:

DO NOT USE STARTING SYSTEMS SUCH AS BATTERY CHARGERS OR START BOOSTERS

TO START THE ENGINE AS THEY MAY DAMAGE THE ELECTRONIC CONTROL UNITS.

• Do not check the charge of the battery by connecting the two poles with a metal object. Use a

voltmeter.

• The battery earth connector (-) must always be the rst to be disconnected and the last to be

re-connected.

• The sulphuric acid in the battery electrolyte is poisonous. It can burn the skin, pass through

fabrics and cause blindness if it comes into contact with the eyes.

• Please note that lead and its compounds cause cancer and other damage to reproductive

organs. These substances are present in the battery poles, terminals and accessories. Wash

your hands after touching them.

DANGER: