ENERGREEN RoboMAX - Periodic Replacement of the Safety Components; Track Maintenance; Checking the Track Tension Pressure

89
© 2017 Energreen Srl
Professional machinery
DANGER:
• Never check the battery charge status by connecting the two poles with a metal
object, use the voltmeter.
• Always disconnect the earth connector (—) of the battery rst and reconnect it last.
• The sulphuric acid in the battery electrolyte is poisonous. It can cause burns to the
skin get through fabrics and cause blindness if it comes into contact with the eyes.
• Please note that lead and its compounds cause cancer and other damage to
reproductive organs. These substances are present in the battery poles, terminals
and accessories. Wash your hands after touching them.
9.10 - PERIODIC REPLACEMENT OF THE SAFETY COMPONENTS
To guarantee safety at any time while the machine is being used, the operator is required to make the
replacements listed below.
Periodically replace the safety components
Component Years Hours
Fuel pipes 2 4000
Hydraulic pipes 4 4000
9.11 - TRACK MAINTENANCE
9.11.1 - CHECKING THE TRACK TENSION PRESSURE
This is a check to carry out every 50 hours for the conservation and the best maintenance of the
belts to avoid the accidental movement out of their seats.
A
B
To check the pressure:
1. Remove the cover (A).
2. Place the nozzle of the pump onto the grease valve (B); check the pressure on the pressure
gauge when injecting grease. Refer to the following table for the pressures of the various
tracks.
3. Replace the cover (A).