EasyManuals Logo

enphase IQ Combiner 5C Quick Install Guide

enphase IQ Combiner 5C
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
Section C
Wiring
Drill conduits
The bottom and sides of the IQCombiner5/5C are the best
locations to drill holes for conduit ttings. The rear conduit entry
below the busbar assembly is also supported.
Use a snap punch or other type of center punch to prevent the drill
from wandering. Drill a pilot hole with a smaller drill before using a
step drill bit.
Use only UL Listed rain-tight conduit ttings for wire entry into the
enclosure .
Recommendation:
1
4
3
2
1
IQBattery
2
PV - Bottom
3
Output to main load center/IQSystem Controller
4
Control cables
Risk of equipment damage. Do not drill conduit holes on the
top of the box or at any location that allows moisture ingress.
When drilling, consider the internal parts of the combiner.
Make sure that the holes do not interfere with the internal
workings, mechanics, or the dead front legs in the corners of
the combiner.
Best practice: Use a stepped drill bit to make the conduit holes.
Using a hole saw may crack the plastic housing.
As an alternative, use a sharp chassis punch with caution.
IQ Combiner 5/5C Quick Install Guide 20

Other manuals for enphase IQ Combiner 5C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the enphase IQ Combiner 5C and is the answer not in the manual?

enphase IQ Combiner 5C Specifications

General IconGeneral
Brandenphase
ModelIQ Combiner 5C
CategoryInverter
LanguageEnglish

Related product manuals