45
5.2.7 Output Parameter Settings
When an output or input/output module is connected to the device, the purpose of the output is
selected from this menu.
The number of appearing menus depends on how many outputs are available on the connected
module.
Digital output of the device can be used for one of the following applications:
1. Output as Pulse: When this option is selected, the device creates output pulses depending on
selected value of active or reactive energy consumption.
2.Output as Alarm: When this option is selected, the output changes from logic-1 to logic-0 if the
selected parameter exceeds or is below the limit value.
When the alarm condition is resolved, output returns to logic-1.
1. Output as Remote Control: When this option is selected, the user can change the output of
the device from logic-1 to logic-0 remotely via RS-485 communication.
The remote output can be changed with the corresponding Modbus register address 0x0A. In this
way, its output can be used to remotely switch a circuit on and o.
To Next Page
Loading...
