Section 7: Using the Epilog Dashboard
105
Color Mapping allows you to control the following six laser functions for each
color in the Map List:
Color – Select the color you want to use or modify.
Speed – Sets Raster speed and Vector speed for all objects of the color.
Power – Sets Raster power and Vector power for all objects of the color.
Freq.- Frequency is a parameter that is only used on vector objects. It will have
no effect on raster engraving. Color Mapping allows you to set different
frequencies for different vector colors within a single job setup.
Focus – Each increment of one will change the table height by 0.0005 inch
(0.0125 mm). A minus sign in front of the number, -.250 for example, will move
the table up (closer to the X-beam) by 1/8 inch (approx 3 mm). Because the
adjustment increments are so small it may be easier to think of the change as a
two digit change being equal to 0.001 inch.
Raster – Colors that are set to “Yes” will raster engrave at the speed and power
settings for that color. Colors that are set “No” will be prevented from raster
engraving.
Vector - Colors that are set to “Yes” will vector cut at the speed and power
settings for that color. Colors that are set “No” will be prevented from vector
cutting.
To Next Page
Loading...