Epilog Laser Zing 10000 - Step 2: Setting up the Computer’s TCP;IP Address

Section 5: Installing the Epilog Dashboard
Print Driver
29
Step 2: Setting up the Computer’s TCP/IP
Address
Once you have set the IP Address on the laser you will need to set the TCP/IP
Address in your computer.
1. From the Start menu at the bottom of your computer monitor screen select
Start | Control Panel | Network Connections.
2. Highlight the Internet Protocol
(TCP/IP) option.
3. Then click on Properties.
Right mouse click on the
Local Area Connections
icon, then click on
Properties.