Section 5: Installing the Epilog Dashboard
Print Driver
30
4. The window below will appear. Select Use the following IP address radio
button.
5. Type in the following (leave everything else blank on this page).
IP Address 192 168 3 3
Subnet Mask 255 255 255 0
Default Gateway Leave blank
6. Click the OK button in this window and then click on the Close button in
the next window.
7. Your computer is now set to print through a crossover cable to the Ethernet
port on the laser.
This number is not an error --
the last digit of the IP address
in this window only must be
different than the IP address
set in the Epilog Zing.
To Next Page
Loading...