Section 7: Using the Epilog Dashboard
56
Now that you have printed a simple job, you are ready to gain a better
understanding of the different printing options available from the Dashboard.
Most engraving and cutting jobs can be accomplished by using only the General
tab. Advanced features for more complex jobs can be found under the Advanced
and Color Mapping tabs.
Note! – When using the slider bars, there are several different ways to get the
desired setting. These different methods all follow standard Windows protocol,
so they will work in other Windows software applications too!
You can move the settings in increments of one by using the + and – icons.
You can move the slider in increments of ten by clicking close to, but not on, the
slider. If you hold down the Alt key on your computer keyboard while clicking
close to the slider will bring up the dotted box outlining the slider and will allow a
little better control of moving in increments of ten. Clicking directly on the slider
control (the little box in the center) will also bring up the dashed outline.
To Next Page
Loading...