Section 7: Using the Epilog Dashboard
69
Engrave Direction
This feature applies to Raster engraving only and allows you to engrave your
project either from the top down, or the bottom up. This is very helpful for some
materials like plastic or rubber stamps. In standard top-down engraving there can
be a large amount of engraving debris generated. As the debris moves towards
the exhaust plenum, some of it collects in the area that has just been engraved.
Bottom-Up engraving prevents the debris from collecting in the freshly engraved
spaces.
Top-down engraving starts from the
top and works its way down.
Bottom-Up engraving starts from the
bottom and works its way up.
To Next Page
Loading...