Epilog Laser Zing 10000 - Page 84

Section 7: Using the Epilog Dashboard
70
Center Engraving
The Center Engraving Option allows you to define the center of your artwork as
the primary reference point (Home position) of your engraving or cutting. The
Center Engraving Option has been designed to be used in conjunction with the Set
Home feature of the laser. This differs from standard printing where the upper
left corner of the page and the upper left corner of the laser table define your
primary reference point. There are four options for centering your artwork:
1.
2.
3.
4.
Page-Center