Section 7: Using the Epilog Dashboard
72
There are some limits to the maximum size page you can use and the placement
of your artwork on the page. If you have a mismatch with your artwork
placement and your page size you will see a “Position Error” on the keyboard at
the laser. You will need to adjust your page size and/or artwork placement and
print the job over again if this happens.
5. If your page size in your graphics program is gigantic in relation to your
artwork size, you may need to reduce the size of your page. There is no
formula for what page size will not work, but normally the only time a job
will not print is if the page size is way out of proportion to your image size.
6. Also, don’t place your artwork too close to the lower-right corner of your
graphics page. If your artwork is too close to the lower-right edge of your
page – and the page size is too big – you may need to adjust where you
place your artwork.
The Center-Center concept is best illustrated with an example:
Example #1: Let’s say a customer brings you an odd shaped piece that already
has artwork on it and he wants to have a name engraved to finish the piece.
Because of the shape of the piece, the location of the engraved name is not easily
defined by using traditional X-Y coordinates.
The name
needs to be
engraved here.
Why Me??!!!!
Land Lubber Award
Fewest Fish Caught!
x
To Next Page
Loading...